Help me with coding for Arduino CAN Reader
$30-250 USD
Dibayar semasa penghantaran
We are developing a device that reads CAN messages from a vehicle or other device and then triggers outputs depending on certain conditions. We need assistance with the code development, as my programming skills are not proficient enough and due to time constraints this project needs to be completed. I have the Arduino Leonardo board and the CAN transmitting device on bench and ready to actively test code when required.
In a nutshell, I require the code that takes values from an array set by a Library for the MCP2515 CAN transceiver chip, convert the values to binary, take the binary bits then place them individually into another array. Then the code needs to read specific cells, compare the values to a list of defined conditions then store them as variables to be used for triggering outputs or serial printing, depending on the future application of the CAN reading device.
I can provide a document that further explains the technical process if requested.
The code will also require detailed commenting so that I can learn how it was achieved and also in case any possible minor adjustments need to be made in the future.
ID Projek: #30104484
Tentang projek
11 pekerja bebas membida secara purata $192 untuk pekerjaan ini
Hello, I can help you for this CAN protocol based Arduino coding. I have experience working with CAN protocol, CANBUS, MCP2515 CAN transceiver. We can discuss in detail over chat.
Hi I might be able to help you with MCP2515, i ever used it while ago, i can make a good documentation, and if you want i can give explanation of each method
Hi Hope you are well. This is Sam, an embedded system expert. I have reviewed your requirements and they fit my skillsets. In your project, the Arduino board is connected to the CANBus via the MCP2515? So do you need t Lagi
Hi I'm Faiz from Malaysia I have skills in developing and debugging microcontrollers. From your statement, I can imagine that you want to convert HEX into binary and push into 8x8 array, call arr[0][5] to get ON/OFF s Lagi
The project is very easy as I already have developed EV chargers using STM32 bluepill on arduino platform and have a CAN code developed for the same I need only 1 day to develop the code for CAN on Leanardo board.
