ATMEL ARM Board Bring-up

Hello, I have 10+ years of Experience in Embedded HW product design with multiple domains like a consumer, industrial, automotive, IoT, and wearable products. -Hardware architecture design using MCU, controller, and FPGA, as well as low power battery, operated device -Experience in all phases of product development from prototyping to mass production -Experience in Schematic design and high-speed PCB layout board design with multilayer PCB design, Blind & Buried Vias in HDI design using Altium design, Cadence Allegro/Orcad PCB Designer tool. -Working experience on power management system design with Buck-boost, Battery charger, and fuel gauge, USB3.0 Ctype and PD charging, POE and etc -Expertise in design and simulation of analog circuits, -Experience in Microprocessor and microcontrollers like NXP, ST, Microchip, Marwell, Qualcomm, MediaTek, TI, Renesas, and Atmel -Expertise in wireless SOC with BT, WIFI, 4G, Lora, Zigbee from NXP, Nordic, Ublox, Qualcomm, Cypress, Broadcomm, TI, ESP, Silabs, Microchip -Experience in wire interface USB2/3, SPI, I2C, UART, HDMI, Ethernet, SDIO, MIPI-CSI/DSI, CAN, Modbus, RS232, RS485-EMI / EMC compliance and product certification like CE/FCC/UL and etc -Expertise in hardware testing and troubleshooting/root cause If you award me the project, I’d be pleased to discuss this further and will define milestones and price after requirements finalization. Looking forward for your earliest response. Thanks. Alpesh