Create a circuit diagram for me
Bajet €8-30 EUR
Job Description:
I need a circuit diagram that fulfils the following conditions:
1) It must be controllable via a program (it doesn't matter if there are already open source programs for this or if I have to create one myself - it just must not work via a mechanical operation).
2) All products in the circuit diagram must be purchasable in Germany.
3) All exact products must be declared (e.g. controller Designation).
These are the exact specifications:
The circuit diagram is to be drawn within the white box (see attachment).
1:
Can be connected to 10 or 19.
Vmax: +/- 40V
Current: +/- 120mA
One wire.
2:
Can be connected to 9 or 18.
Vmax: +/- 40V
Current: +/- 120mA
One wire.
3:
Can be connected to 10 or 19.
Vmax: +/- 40V
Current: +/- 120mA
One wire.
4:
Can be connected to 11 or 12,13,14,15.
Analogue signal
Voltage Range: +/- 6 V
seven wire
5:
See 4
6:
Can be connected to 16.
Analogue signal
Voltage Range: +/- 6 V
five wire
7:
see 4
8:
Can be connected to 17.
Analogue signal
Voltage Range: +/- 6 V
Five wire
9:
see 2
10:
see 1/2
To avoid complexity, only one connection is possible at a time.
This means e.g.
1 cannot be connected to 10 and 19 at the same time.
11 cannot be connected to 4 and 7 at the same time.
etc.
Dianugerahkan kepada:
Hi need more information about the project I can design schematic, PCB and write the firmware for you I have experience working with Altium designer. I can send you some of my previous design with Altium I am an elect Lagi
8 pekerja bebas membida secara purata €139 untuk pekerjaan ini
They say the Germans enjoy over-engineering for good, and so do we. Building an electronic system is a bit cumbersome. Yet, if you have a team of experts with knowledge, skills, and techniques. Then, it could be a wal Lagi
Hello Dear I can support you at your project depend on my experience at circuit design and programming do you prefer to use a specific type of controller also the box we can design as a 3d model by solid works I am Lagi
Hi I am an electronic engineer with rich experience of over 7 years So I think I can finish your project perfectly Please let me discuss about your project in detail Thanks Tran
Hey there , My name is Rachid, I am an electronic developer with experience in developing complete electronic products, including electrical schematic design, PCB design, firmware development, testing, etc., I can star Lagi
Hello, I'm a mechatronics engineer with real experience with electrical circuit design and simulation, I will make your circuit via proteus simulation and check everything is working fine through simulation, and also c Lagi
Hi friend, My name's Hieu, an Electric Engineer, I'm good at Power, Charger and wireless also. I see your request but i think we need a conversation for more information. Please contact me for best result Regards,
