Build a system with PWM, CAN, MQTT, Power Line Communication (QCA7000)
€750-1500 EUR
Dibayar semasa penghantaran
Hi everyone,
We need someone who can build a system which contains the following topics:
- The algorithm will firstly need to make a PWM signal from 1khz with an adjustable duty cycle from 0-100%.
- Depending on an analog signal that will be acquired through an ADC chip, the program will go into different states.
-When a specified state is reached, there needs to be communication with a QCA7000 chip (power line communication) which will in turn talk to an external device.
-There shall be need to implementing DIN and/or ISO norm
-There shall be need to set up the SLAC protocol
-Another program needs to read/write GPIO and has to communicate over CAN with an external device
-Both these programs need to be able to communicate with a device through a yet determined protocol/device
-These programs should communicate externally through MQTT
If you need any further details, please PM me.
ID Projek: #27568614
Tentang projek
14 pekerja bebas membida secara purata €1194 untuk pekerjaan ini
Hi I am experienced electronics engineer with more than 13 years of experience. I have read the details and have a few questions and want to know more about the requirements. I have signed the NDA , more details can be Lagi
Best PCB Design Expert at your service! Dear Client, I can build a system with PWM, CAN, MQTT, Power Line Communication After going through your project details, I am happy to inform you that these are an exact match Lagi
Hello I have more than 15 years of experience in the embedded systems design and pcb design and electronics systems design So let's discuss your project in chat
Hello, I can help you on this requirement. Please check my profile for more details about my skills and experience.
I have been discussing this project with your colleague Stef32 for several weeks. My experience is within the embedded systems industry designing PCBs, firmware, and low level software drivers. My proposal budget and d Lagi
Hi Only developer who has deep learning in electronic can understand this project. I am a developer who has an honest mind and the best skill in web development and electronic. Delivery in time and the perfect result a Lagi
Hello, thank you for your job posting. As a senior electrical engineer, I have plenty of experience in PCB design and firmware development. Design circuits and PCB: Altium, Eagle, KiCAD, Allegro & OrCAD, PADs. The ser Lagi