Dibatalkan

Circuit design and prototype - piezo pressure transducer and LED indicators

I require a circuit design and prototype for a medical device that will convert hand grip pressure on a cylindrical object constructed of medical grade silicone to a LED Readout. The LED 5-bar readout will have red red amber amber green indicator of handgrip pressure on the cylindrical silicone bar. The bar readouts will indicate levels of pressure from soft (bottom red) to firm (green) Actuation of the sensor/readout will occur on application of pressure. De-activation will occur ~60 seconds after last activity. The power source will be a button battery. The construct must use smallest possible components. The sensor must operate being encased in Medical Grade Silicone. As it is a medical device, the sensor must be able to tolerate (in off state) 140 degrees Celcius in an Autoclave. The LED readout and power and driver circuit will be detatchable to avoid autoclave. The force range would be 0 - 100kpa, and the sensor preferably must be cylindrical and measure lateral forces on the cylinder of med grade silicone. This will be used to measure grip strength of infants. Smaller is better.

A sensor range need to be indicated due to dampening of the force due to the Silicone. That is - the grip strength will be 0 - 100kpa, but I need to be able to interchange the sensor to accommodate the dampening effect of the Silicone till I get an appreciable reading. The other way that this could be acheived is calibrating the MCU to account for the loss of sensitivity.

Over to you . The bid will include 1 Comprehensive Circiut Design and component list with specs, 2 Working Prototype (not including silicone encasement) 3 Posting the prototype to Canberra Australia - Address to be supplied to winning bid. 50% payment will be made on submission of circuit design and component list. vWorker delivering circuit design and component list, and receiving monies, and not delivering will get a negative rating and go to arbitration.

## Deliverables

1) All deliverables will be considered "work made for hire" under U.S. Copyright law. Employer will receive exclusive and complete copyrights to all work purchased. (No 3rd party components unless all copyright ramifications are explained AND AGREED TO by the employer on the site per the worker's Worker Legal Agreement).

## Platform

N/A

Kemahiran: Elektronik

Lihat lagi: working prototype, work in canberra, work canberra, prototype power list, prototype made, prototype component, prototype activity, need a prototype made, medical work in australia, medical device design, law firm site design, lateral hire, hire electronics, grip design, get prototype, get a prototype made, employer power, component prototype, complete prototype, canberra work

Tentang Majikan:
( 34 ulasan ) Canberra, Australia

ID Projek: #3555457

4 pekerja bebas membida secara purata $584 untuk pekerjaan ini

EEmbedded

See private message.

$850 USD dalam 14 hari
(8 Ulasan)
4.3
vw11221122

See private message.

$85 USD dalam 14 hari
(19 Ulasan)
4.2
paxtontechnology

See private message.

$382.5 USD dalam 14 hari
(0 Ulasan)
0.0
hypercoder

See private message.

$1020 USD dalam 14 hari
(0 Ulasan)
3.4