I want a standard servo signal, see below (supplied by my hardware):
(Output Signal: Default range - [url removed, login to view] – [url removed, login to view] ([url removed, login to view] center).
(maximum range [url removed, login to view] – [url removed, login to view])
to control a servo within a 100 meter range over 433MHz UK non license transmitter.
The signal must control a standard digital or analogue servo powered by a standard (PP3) 9V battery.
Therefore the hardware should be:
1 x TX circuit with antenna to receive a standard servo signal
1 x RX circuit with antenna to receive the signal from the transmitter and control the above (digital/analogue) servo.
I want quotes for either design of PCB's with components list and/or fully working prototypes - to be included in my final product.
Hope this makes sense please contact if further information is required.
12 pekerja bebas membida secara purata $592 untuk pekerjaan ini
Dear Sir, Good day to you from SANDS. Kindly refer to your PM for more details including the technical proposal of the project. Thanks & Regards, SANDS Team.