I am looking to build a compression tester for mazda wankel rotary engine. This will involve a 0-10 BAR pressure sensor outputting 0.5-5Volts. This signal is to be fed into an arduino uno with keypad LCD shield. The rotary engine has 3 seperate compression cycles (1 per rotation). RPM will need to be determined by counting the time between peak pressure values. The average peak value will then be required for each of the 3 rotor faces. This output will need to be "normalised" to 250RPM as per a predetermined graph table.
24 pekerja bebas membida secara purata €256 untuk pekerjaan ini
Hello, I am an Electronics and Embedded system developer. I have experience in Digital and Analog electronic design and Matlab. Kindly check my profile. Reply me back and will discuss the details further. Thankyou
Hello! I've been dealing with microcontrollers and sensors of various types since 2000. Apparently I have an experience in attaching of the pressure sensors to MCU Thus I guess I can do this job. Thank you.
I have 4 years experience in embedded systems . I have completed many projects on arduino. with pressure sensor and key pad and also LCD .so I can do your job within a time limit with your satisfaction.