Data Acquisition 25Ms/s

Research (Phase 1),

need a AtoD solution, that

interfaces DMA to a typical computer (PCI/PCI-X/PCIe) 64bit mobo.

(could be intel/amd processor).

Must mount compact (i.e. riser L card?), or via cable?

Must work with Linux OS, and programmable fully by C.

Most important, must be able to capture analog and convert to

digital (10,12,16 bit?), at 25Ms/s or higher (even to 100Ms/s.

Solution may be custom build?

Solution should not be expensive, i.e. if a off-the-self exists for

1000.00$ that would be the solution (for this phase), if

its $5000.00, then one needs to seriously look at custom build.

In a future phase, a custom build will happen, to mass produce this

and at a cheap cost. i.e. 100-400$ US for a pci-? card, suited to a refined task.

At this stage in the project, (Phase 1), all is required is research.

What products out there, if any, can do this, and for how much?

If expensive, is the next phase a custom build.

Other issues like differential sampling (verses reference), and

protection of the electronics to damage also have to be considered.

Also, a combination of slower A2D's is not acceptable, it must be a single input able to sample 25Ms/s+.

This spec. can be expanded upon if need be (bidder has more questions)

Future phases will include software development, and custom build

(based on findings of this phase).

Extra consideration may be given to bidders who have abilities to take on future phases.

Will probably except multiple bidders, to have benfit of two or more

people working on it, so nothing is missed.

I can except a single bid on this one, and issue another project to another bidder.

Money will be placed in escrow.

Except delivery in 2-3 parts, and release of escrow same.

i.e. (1) initial possibilities

(2) short list

(3) results including contact with vendors and/or data sheets etc.

project budget can lead to more if tasks become more involved.

The following is the best I have found:

8-bit A/D PCI Express x1 board. 50 MS/s $3,499.00


supported by Linux and C programming

So I am looking for something as capable, but cheaper.

If you have a very good idea to build one, and it would be inexpensive, then that is of interest too.

I will also post another brother project of this, to do with a strobe, that might be of interest.

Sorry, had to extend, just in middle of buying home, and cannot get time to finalize this, hopefully this weekend or shortly there after.


Kemahiran: Elektronik, Kejuruteraan

Lihat lagi: working for intel, what's escrow, what is data input, software development phase, software development cheap, how much escrow, future electronics, escrow's, escrow parts, escrow l c, engineering lead, data bit, cost of software engineering, cost of linux software, cheap produce, cable one, bit data, be electronics engineering, protection engineering, how much is escrow, escrow protection, escrow card, digital escrow, cost of escrow, cheap software development

Tentang Majikan:
( 4 ulasan ) toronto, Canada

ID Projek: #278703

8 pekerja bebas membida secara purata $175 untuk pekerjaan ini


Hello, We are an Electronic Design House based in Pune, India specializing in Prototype Projects and Design Documentation. We have a strong technical team that specializes in Embedded Hardware , Firmware and PC Based S Lagi

$250 USD dalam 20 hari
(3 Ulasan)

Hi , I'm an engineer who worked a lot with data aquisition hard and soft .I had various projects involving DAQ from scratch to sofware development. I think your project can be done with existing hardware ...

$120 USD dalam 5 hari
(0 Ulasan)

Please see PMB

$30 USD dalam sehari
(0 Ulasan)

Dear sir, i looked the issue you discussed. i am very highly interested in this. please go through the PMB. thanx

$150 USD dalam 10 hari
(0 Ulasan)

Hi, Good project to bid for. I am sure you are not aware of the prices. The hardware cost around 25k to 30k i.e around($750) in India. Who will bare this expenses? If you want a interface, I will get this done in a Lagi

$250 USD dalam 2 hari
(0 Ulasan)

Greetings. My name is John and I am aerospace/electrical engineer for a defense company. I have experience in this exact application that enables me to produce valuable research for you in a short period of time for Lagi

$100 USD dalam 5 hari
(0 Ulasan)

Hi, I have accomplished two similar designs. They are both in mass pro. (32-bit and 64-bit versions PCI 2.2) Please see the PM.

$250 USD dalam 120 hari
(0 Ulasan)

Hi ! I am not sure that weather i am going to get the project or not . by my experience has been on designig a PCI software radio , which did bandpass sampling of the 70MZ IF. we used the 40MSps AD by TI. That was Lagi

$250 USD dalam 10 hari
(0 Ulasan)