Ditutup

Honda VT750 Shadow Motorcycle to BOBBER

I would like to be able to get certification to cut the rails that support the 2nd seat from a 2004 Honda Shadow VT750 - after the 2nd seat has been removed and shorten the 'look' of the bike. The twin rear shock absorbers mount to the frame (it looks like die cast metal in this area) and the rear seat has supports which extend past this point which I'd like to remove by way of a power cutting tool and then refinish to appear stock. It appears there is just two protruding arms that are not structural as there is no cross brace past where I wish to cut them off. If anyone has any experience here I would greatly appreciate your advice.

*****I need a automotive engineer to certify the project.

Kemahiran: Kejuruteraan, Local Job

Lokasi: Varsity Lakes, Australia

Tentang Klien:
( 0 ulasan ) Sydney, Australia

ID Projek: #34058345

4 pekerja bebas membida secara purata $513 untuk pekerjaan ini

androaiad

Hello, I am an experienced engineer. I am expert in stress so I can help you for sure in your project and I will provide the required design in the required time. Please check my portfolio and reviews. Thanks.

$500 AUD dalam 4 hari
(142 Ulasan)
7.5
(7 Ulasan)
4.6
(2 Ulasan)
4.2
Bankanthonynels6

Im the best for the job, i expertise on 2 stroke and 4 stroke engines. This will be a small task compared to my past jobs. I do hope you reach out.

$500 AUD dalam 7 hari
(0 Ulasan)
0.0