Bajet ₹600-3000 INR
There is a schematic diagram of a performed experiment with PZT-5H discs arrangement with all the setup and equipment. In the experiment was performed in a busy road where only 2 wheeler vehicles were allowed to pass with a particular speed and time range and all the factors were recorded by respected sensors. We have all the data. Need a simulation based on the experiment performed on these points in mind.
1. All the parameters are needed,
2. If performed in ansys will prefer if the work is done in 'piezo and mems' extension for voltage parameter if
3. Will prefer to the simulation to be as close to experiment as possible.
I am open to new ideas or discussion of simulation if needed. Even further discussion if needed can be done.
7 pekerja bebas membida secara purata ₹4200 untuk pekerjaan ini
Hello Sir i am computer engineer and certified Labview architect and developer so may i can help you , thanks
hey understood the details that you are looking for the Piezoelectric Simulation in ansys please share the details over the chat thanks
" Piezoelectric Simulation Expert here" I have done some projects based on piezo technology. I can help you to get proper simulation results by using Ansys. I hope you contact me as soon as possible. Thankyou regards
This I can handle in the least time possible using COMSOL MULTIPHYSICS. I have implemented more than 100 projects using the FEM solver. Let me know about your setup I will get started immediately.
Hello I can do this. Please share the details of the task so that I can check and confirm accordingly.
Hi there, I am a Certified LabVIEW Developer and has 8 years of industrial experience in developing application in LabVIEW and has built many applications that handles sensor data and displays them on graphs, charts et Lagi