Step 1 Create a schematic diagram. You may create your schematic in either Eagle or PADS Logic.
Step 2: Import the schematic diagram into PADS Layout.
Step 3: Create the Gerber files for manufacturing the board
You need to send the following: bottom layer, top layer, outline, and drill. Include the board file as well. The extension changes depending on the software.
Pad Stack 30 mils
Clearance 14 mils
Trace Width Max: 180 mils
Min: 18 mils
•pcb design must meet the following drill bit guidelines:
Function Size (mm) Size (mils)
Trace 0.5 20
Trace 1.00 39
Trace 2.00 79
Drill Hole 0.5 19.7
Drill Hole 0.6 23.6
Drill Hole 0.7 27.6
Drill Hole 0.8 31.5
Drill Hole 0.9 35.4
Drill Hole 1.5 59.1
• Only PCBs from PADS are supported.
Use only the drill size specifications listed above to avoid DRC failure).
The Schematic to be designed is attached to the word document.
27 pekerja bebas membida secara purata $162 untuk pekerjaan ini
Hello there. I have good experience with pcb design and layout. I am senior embedded engineer, so can handle firmware also as well as pcb design. Please contact me and discuss details. Regards.
I am Embedded hardware Engineer. I have experience of schematic and layout in Altium and Eagle. I will able to provide you in PADS too. Let's start the work.
Hi, Dear. I am an electronic engineer and PCB designer. I have designed lots of gadgets, IOT devices, PS units, and so on. I can deliver you high quality design. Thank you.