Sedang Disiapkan

A small 4 Layer PCB Layout modify

We have a 110mm X 111mm 4 Layers, one 120mmx36mm 2 layers and 102mmx25mm 2 layers PCB layout need to modify.

The 120mmx36mm 2 layers only connection need to modify and there is only 26 components .

The 102mmx25mm 2 layers change to different connector and only 4 connector components.

These above two boards only little modify.

The 110mm X 111mm 4 Layers is about 30 change items.

Including modify drill hole size, change component size (C0603=>C0402), change component side, re-layout the DIP jumper etc.

We will provide you the netlist file.

You must use allegro (above 16.0) as layout tool.

Kemahiran: Susun Atur PCB

Lihat lagi: layer pcb layout, layers pcb, layout modify, small little, pcb, pcb layout, layout pcb, dip, layout allegro, pcb components, change layout, layout layer pcb allegro, pcb need, hole hole, ns2 modify mac layer, pcb design small ups, layout relay pcb, layout need, need pcb, pcb file, small electronic projects microcontroller ckts pcb layout, different modify, modify size, freelance layout design pcb, pcb layout recommendations small power supply

Tentang Majikan:
( 1 ulasan ) Cheng-Ho, Taiwan

ID Projek: #1569656

11 pekerja bebas membida secara purata $181 untuk pekerjaan ini


Dear sir, We can provide the PCB modification service. Please check PMB for business process and bid details. regards,

$180 USD dalam 8 hari
(6 Ulasan)

Dear Sir, We are Reserach and Development company whose working area are : -Digital Motor Control -Analog Design -Electronic Design -Power Electronics -PCB design -Embedded system -Matlab -Simulation of ha Lagi

$220 USD dalam 2 hari
(4 Ulasan)

Hello, I have more 10 years experience with PCB design.

$220 USD dalam 3 hari
(0 Ulasan)

please check your MB.

$200 USD dalam 2 hari
(0 Ulasan)

I have 6+ years of industrial experience in board design ( Schematic, Layout ) in Allegro and Orcad software.

$200 USD dalam 7 hari
(0 Ulasan)

Sir, I have the experience in high speed PCB design. I would like to assist you in the job that you have mentioned. i guarantee the quality and efficient output. Thank you

$200 USD dalam 5 hari
(0 Ulasan)

Hi, I can do it.

$180 USD dalam 3 hari
(0 Ulasan)

Maybe it is a beter way to make new one from schematic? If you vant there is no problem on your way...

$200 USD dalam 5 hari
(0 Ulasan)

I can do this qualitatively.

$200 USD dalam 6 hari
(0 Ulasan)

I have handled a lot of PCB software, like Allegro, PADS, Expedition, so I think I can do the job.

$100 USD dalam 5 hari
(0 Ulasan)

We have more than 5 years of experience in making Electrical design engineer's product dreams into reality by development of Multi-layer printed circuit boards. Designed up to 22 layers, using latest technologies, like Lagi

$90 USD dalam 5 hari
(0 Ulasan)