I am looking to 3d print a case and container for a small motor to power my canoe.
The case will contain:
2 x 10cm diameter motors with impeller
12 batteries in Battery cases
2-4 round switches
I have mostly drawn the above as components in 3D already and can give precise measurements for anything I have not drawn.
The housing will need a lid which can open and close to replace batteries.
The support I need is to create a model in 3d which will involve:
Creating a housing that will mount to a model I have drawn of the boat
Creating tubes within the housing to flow the water from the base of the housing, through the cyclone filter to the impellers.
Create tubes to flow the water back out again.
I will provide a sketch design for the housing and specifications for the tube diameter etc.
In addition to the above I would like to integrate some of these things from thingiverse.
Clamp to attach/detatch the housing from the craft
[login to view URL]:2477698
[login to view URL]:2596197
Cyclone Filter on intake
[login to view URL]:2829268
Hinge to allow the model to fold if it looks like it could
[login to view URL]:61978
Gimbal or camera mount point
[login to view URL]:2826759
And possible a carry handle.
I am looking to work with someone live, tomorrow between 2PM GMT and 8PM GMT. I wont have time outside these hours so please ensure you are available.
Ideally your grasp of english will be quite good.
I am patient and usually fun to work with.