Control of microgrid via VSC converter using Simulink/Matlab. -- 4

I am an italian engineer and working on a bachelor project to be handed over beginning of September, so I am in kind of a hurry since I'd have to write a report too. I attached here a COMPLETE GUIDE to follow so you can see immediately how much work there is to be done. It is about control of a microgrid via voltage source converter with integration of storage, wind and solar power in the grid using Matlab/Simulink. I already modelled some parts (but had problems to make them work) and have some papers you could work from to obtain the graphs and data I need. From paper 'chapter 1' I should obtain all the graphs, for example. Then I should include the pv system (simple matematical model, already modelled with MPPT and converter), a wind turbine (type 3 generator, already modelled and with rotor/grid side control functioning but with rated power and voltage to high to be included in a 400V microgrid, so that it would be important to find other parameters and make it work anyway), a storage system (simple and partially modelled) and some generic ac and dc loads in the microgrid and simulate the Vsc behaviour under different conditions (voltage sags, unbalances voltages,...). Attached some of the work I did in Simulink (just to give you an idea of the level of the modelling, nothing too difficult I believe), a document where I should get all the graphs from this simulink model, and the GUIDE to follow. I already wasted more than a week with people saying they could do it and then showed up random downloaded mathworks files that did not have anything to do with my project. Thank you.