Expert for STM32 Motor Control Workbench with STEVAL-SPIN3201

$25-50 USD / hour

Ditutup

Disiarkan

hampir 4 tahun yang lalu

$25-50 USD / hour

Hello, I need a freelancer expert to handle (consult and remote assist) troubleshooting STEVAL-SPIN3201. Here is the issue description: We configured the motor according to datasheet in the STM32 Motor Control Workbench, however when starting the motor from Motor Control Workbench UI and measuring the phase with oscilloscope, we see constant PWM on all three phases regardless to the HAL sensors output. See the attached image of the scope - channels 1,2,3 are phase voltages relative to ground channel 4 is one of the HAL sensors.

Electronics

Electrical Engineering

Microcontroller

Engineering

Circuit Design

ID Projek: 26583580

Tentang projek

5 cadangan

Projek jarak jauh

Aktif 4 tahun yang lalu

Ingin menjana wang?

Alamat e-mel

Faedah membida di Freelancer

Tetapkan bajet dan garis masa anda

Dapatkan bayaran untuk kerja anda

Tuliskan cadangan anda

Ianya percuma untuk mendaftar dan membida pekerjaan

5 pekerja bebas membida secara purata $35 USD/jam untuk pekerjaan ini

@makeideaalive

Hi! I recently have done a similar project. I worked on medical device which has a bldc motor with STSPIN32F0 as microcontroller. I was configuring motor in Motor Control Workbench. I have a lot of experience with brushless motor. I developed many algorithm for control them like trapezoidal commutation sensorless or with hall sensor, field oriented control with encoder feedback and more. Check my portfolio and message me to determine the details.

$30 USD dalam 40 hari

0.0

(0 ulasan)

1.9

@mustafackmk01

Hello, I master this development board and software. However, I used several boards of the ST. I can help you best.

$40 USD dalam 40 hari

0.0

(0 ulasan)

0.0

@ouseppachacr

I have worked in the STEVAL - SPIN3201 board and i have this board with me.I have seen the cro pwm image.i can describe more about that through private chat.

$28 USD dalam 10 hari

0.0

(0 ulasan)

0.0

@maheshrsharma8

I have excellent experience in motor control algorithm development on STM32 workbench .i developed the drivers for MOTOR CONTROL ac,stepper,dc,servo and all other .I developed this type HAL sensors with single and 3 phase control for motor control drives

$29 USD dalam 40 hari